Cinebench R23 was released today for download, and it is MUCH HARDER on the CPU than R20, I even had to lower my overclock to pass it. Mods can we get this stickied, as a very common complaint is "My processor is underperformning", and this will provide a thread of reference that's not a stock, clean system like the review sites use.
Similar to the R20 thread, please post the screenshot below, and add your RAM capacity and speed in the notes.
After installing a second CPU Cooler fan (200 CFM) I am able to stress my Ryzen 7 3700X without overheating or throttling. Using 32 GB 3600 Mhz G-Skill RAM. PBO on default BIOS setting of "Auto".
You have the same Processor and RAM speed and amount of GB as I do yet your Multicore results are 1200 points higher than mine at stock settings except I have my RAM set at 3600 Mhz in BIOS.
Your single core results are 66 points higher than mine.
So if your processor is Overclocked it does make a difference.
I see that Black Zion also has his processor Overclocked and both of your scores are fairly close to each other.
Not overclocked... if you look closely at my post, I included the relevant settings I used. But since you missed it, I will post them here
I use PBO (not in the AMD CPU settings, but in the normal BIOS) everything in there is at default except PBO is enabled... no other tweaks or settings adjusted
I then apply a CPU voltage offset of -0.125V
RAM is tuned, but that does not make a difference for Cinebench