- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
XTX RGB Software
Just seen the RGB tool was released, went to install and use it but it doesn't detect my card (MBA reference card from ASRock). Tried a few things myself and nothing changes. The software just says to "Plug in your AMD Device to get started" and if I manually open the firmware updater everything is greyed out
System is a 5800X on a Aorus Master X570, 970 EVO boot drive, XTX is plugged directly into the gen4 x16 PCI-e slot, both monitors are plugged in via DisplayPort.
I have tried a HDMI cable, changing around the cables, wiping and reinstalling 22.12.2 drivers, etc...
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Solved myself, borrowed my brothers PC for a minute and the firmware updater detected it so now it works fine in my system.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check out this thread, you aren't the only one with this kind of issue:
https://community.amd.com/t5/drivers-software/rx-7900-xtx-refrence-card-rgb-tool/m-p/569100#M166109
One user managed to get it working by just connecting one monitor, another one got it working by using a different DP port on the card.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried both of those things, tried different monitor configs, individual, cables, etc. Tried DDU and reinstalling but nothing has changed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Solved myself, borrowed my brothers PC for a minute and the firmware updater detected it so now it works fine in my system.
