Can you check if you connected the pump header to the pump/aio/wc connector on you mainboard? Or did you connect it otherwise .. USB only perhaps? If so I read there is an option to program a higher pump speed at boot, and let icue take over when booted..
also if using a motherboard header, please check to mode (PWM, Volt) .. it should be PWM, but you need to check that for your AIO.
*PWM for fans,.. checking pump
”manual cp”:
Connect the pump's 3-pin cable to the motherboard's CPU_FAN header (Image 1).
| IMPORTANT: Do not utilize voltage fan control on the CPU_FAN header with the pump connected for the best performance experience. |
• Connect all the fans to the included PWM Y-Splitter cable (Image 2).
• Connect the Y-Splitter cable to any open 4-pin PWM fan header on your motherboard.
