Machine: i7 3770 / GA-B75-D2V rev.1.0 / 16Gb RAM / RX550 4Gb / SSD Samsung EVO 250Gb / Windwos 10 22h2
With drivers from 2020 - the slicer works without problems, with drivers 21 and higher - the slicer crashes into an error. Here's the thing.
Screenshots with versions are in attached files. The solution for now is to install the old drivers and the utility for adjusting the fan speed of the Fan Control. We adjust the operation of the cooler, because normally they do not rotate as expected and the video heats up to 80 degrees. Silent mode, allowing you to work at night - 47%, heating no higher than 62.
Naturally, first we remove the AMD drivers downloaded from the site and allow the OS to install the driver itself. The OS first installs the old driver, but then updates and installs the most recent one. You need to roll back the driver.
