I've got a RX 6600 paired with Ryzen 3 4300GE, 16gb of RAM and ReLive does not appear on the software, even after clean installing and updating. Any way to bring it back?
Compare the 6600 driver version in device manager with radeon settings system version.
They should match, and have you disabled the 4300ge graphics ?
In what world they must be same?
You can try to check release date instead, though, i guess
In 'Software & Driver Details'.
Device Manager dates match with the ones on the Radeon Software. However I did not go out of my way to disable 4300GE graphics, as the system only uses the dGPU unless I tell a software (such as Open Broadcaster Software) to encode specifically with the iGPU
I had the same problem, a few days ago, I installed the driver once more and it was solved. it was curious that when I reinstalled it, it gave me a downgrade driver to version 22.8.2
I had to do a cleanup and reinstall of the drivers to solve this. Radeon 6800, about 5-6 months ago.
Did you use DDU to perform the cleanup? I got my RX 6600 about a month ago, I used DDU then installed the card, then the drivers. Should I DDU again in this case? I guess it's worth a try.
Ok well I finally lost all my patience and DDU'd, except RELIVE IS STILL NOT THERE BRUH
My advice, use another driver. I have a W6600, those new drivers are not very good. I use Enterprise 21.q3 or 21.10.2. You're using a RX 6600, i would recommend using 21.10.2. If the relive option is still not there, not sure whats going on.
That problem only shown up when i was using those custom drivers from guru3d.
Hm, might give that a shot. I'll let you know if it works, thanks.