I just recently built a new desktop with the specs below. The only operating system I have been able to install is Arch Linux, and even that is only in UEFI mode. From there I could only boot into a command line since the update drivers for Navi 10 aren't supported in Linux 5.2.x. Once I have a successful install I then install linux-mainline and grub-hook from the AUR with yay to have the newer kernel, and have pacman auto config grub. I set the log level to 8 in grub when booting. And my systems freezes after the last log message shown below.
Specs:
Ryzen 3600
RX 5700
Asus Tuf Gaming Motherboard
16B of Corsair Vengeance Ram
Boot log messages:
kvm: disabled by bios
[drm] amdgpu kernel modesetting enabled.
r8169 0000:06:00.0 en6s0: Link is Down
Parsing CRAT table with 1 nodes
Ignoring ACPI CRAT on non-APU system
Virtual CRAT table created for CPU
Parsing CRAT table with 1 nodes
Creating topology SYSFS entries
pcieport 0000:00:01.1: AER: Corrected error received: 0000:00:0.1
pcieport 0000:00:01.1: AER: PCIe Bus Error: severity=Corrected, type=Data Link Layer, (Receiver ID)
pcieport 0000:00:01.1: AER: device [1022:1483] error status/mask=00000040/00000600
pcieport 0000:00:01.1: AER: [ 6] BadTLP
iwlwifi 0000:05:00.0: Applying debug destination EXTERNAL_DRAM
Topology: Add CPU node
Finished initializing topology
amdgpu 0000:0c:00.0: remove_conflicting_pci_framebuffers: bar0: 0xe0000000 -> 0xefffffff
amdgpu 0000:0c:00.0: remove_conflicting_pci_framebuffers: bar 2: 0xf0000000 -> 0xf01ffff
amdgpu 0000:0c:00.0: remove_conflicting_pci_framebuffers: bar 5: 0xfcb00000 -> 0xfcb7ffff
checking generic (e0000000 300000) vs hw (e0000000 10000000)
fb0: switching to amdpudrmfb from EFI VGA
At this point the system freezes. I also get the same problem when I try to boot with Linux 5.9.11, with the last 7 log messages being the same. Also, I didn't include the log time for the sake of my sanity when typing that out. If needed I can provide them.
