PC Graphics

[shinanoDS]

Greetings All,

I recently purchased and installed a Radeon RX 7600 XT for my PC, replacing the RX 560 I had installed previously. I used DDU to remove all prior drivers before removing the RX 560 and installing the new GPU; however, after installed I get the BIOS screen and then the Windows icon for about 5 seconds before a blank screen/no signal from the monitor.

When I boot to recovery/safe mode, I see Radeon 7600 XT in the Device Manager but when I attempt boot normally, I get the no signal/blank screen again. Once I use DDU to remove the new GPU drivers Windows boots normally. I really appreciate any help.

Motherboard: ROG Strix b450-f

RAM: 16 GB

PSU: Corsair 750X

[shinanoDS]

Ok, so an update.

I updated my BIOS but that didn't work - I get the black screen five seconds or so after the Windows logo appears. I also tried resetting Windows 10 and I got up to the point where it asks which network to connect to. I connect to Wi-Fi and then the screen goes black again.

I removed the RX 7600xt and reinstalled my RX 560 and Windows is able to load successfully again. I am really at wits-end with this and don't know what else to do.

[shinanoDS · Accepted solution]

Update #2:

So, I went out and bought a DisplayPort cable and replaced the HDMI with this...

And it worked! The 7600xt is running smoothly. Closing this ticket, case closed.