- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Issues with RX6600
Hello,
After installing my recently purchased RX6600, Windows started to give me some pretty annoying errors. Every time I restart or turn off the PC and then turn it back on, Windows goes to the desktop but doesn't open anything – no applications, no registry, nothing. The only solution I have found is to keep turning off the PC until it shows me the recovery page where I uninstall all programs. However, after a few hours, the same error comes back. Does anyone know what might be the problem?
My configuration:
Graphics: RX6600
Processor: Ryzen 5 5600G
Motherboard: A520M
RAM: 16GB
Could it be a problem with the drivers, such as the Adrenaline edition, or perhaps a hardware issue?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That's a "software thing" most likely.
When did this started to happen, only after driver install? Try a system restore perhaps. Try going into safe mode, use DDU to remove everything from your last GPU and try again.
If all goes downhill, try sfc or DISM and as last resort a OS system repair or clean install.
Good Luck
