cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

PC Drivers & Software

joriel
Journeyman III
‎12-30-2019 05:19 PM

19.12.2 & 19.12.3 bad for my vega 56

As of now im with 19.12.1 drivers and they run very good on my Sapphire vega 56 playing (only for now) Red Dead Redemption 2 since it launched on steam

when i installed the new adrenalin 2020 (19.12.2) it messed up the whole game.... stutters everywhere, gpu utilization not at 99% like normal (around 50%~75%).... conclusion... unplayable! had to roll back.

than the new 19.12.3 came out so i tried it and at first all the problems i mentioned seemed to be gone but i did notice my wattage was way higher (normally around 200w with oc/uv but with the 19.12.3 around 220~265w!!!)

Conclusion: my card was kinda getting hot... gpu and mem temps close to the 70º where normally im at 58º~60º with older drivers... was getting huge pink artifacts when mem was at 72º and gpu at 70º...

like i said before, now with the 19.12.1 temps, wattage and performance are pretty good!

AMD plz fix this, i want the new software features!

my system:

i7 4770k @ 4.4ghz

16gb ram ddr3

sapphire pulse vega 56 with oc/uv (stock bios)

Monitor LG 29UM69G-B IPS 29" UW-UXGA 21:9 75Hz FreeSync

0 Likes
5 Replies
joriel
Journeyman III
‎12-31-2019 10:48 AM

only me with these issues?

0 Likes
hyevltg3
In response to joriel
Adept II
‎12-31-2019 08:21 PM

Can you retry a DDU (Display Driver Uninstaller (DDU) V18.0.2.1) uninstall then re-install 12.3 ? just to confirm you installed cleanly and this isnt residual settings causing this.

Albeit, I too am having issues with 12.3 on my Vega 64 LC. Tuning section settings reset to default when I click to change another setting, very frustrating. thinking of going back to 11.3 (last 2019 edition)

0 Likes
joriel
In response to hyevltg3
Journeyman III
‎12-31-2019 09:16 PM

i did do a clean install after using DDU in safe mode. same issues

0 Likes
hyevltg3
In response to joriel
Adept II
‎01-04-2020 06:27 PM

Im back on 11.3 and no issues for 4 days now with the software.

I dont plan to upgrade GPU for a few years so I think I'll stay on 11.3 as I just need "working" not all the fancy features of the new 2020 edition.

mbk1989
Challenger
‎01-08-2020 12:23 AM

Hey! I have rx 5700 xt and with Adrenalin 2020 drivers i've experienced higher voltage and power consumption when i let my monitors or my pc go to sleep and wake them up. It was so annoying that i rolled back to 19.12.1 and it works perfectly now. Did you observe high power consumption after waking your monitor or pc up?

0 Likes