- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Gpu vm info
Good morning,
a curiosity about the settings of a Rx580 (all values standard). Why this value in the settings management, is higher than the following? Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Very Weird.
I would reset adrenalin to defaults and try again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe it's specific to the card make/model vbios settings ? There are multiple vbios variations between makers/models.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The bios is original (also in comparison with others it is always the same) and the setting is the standard one.
I try to understand why in this step, the voltage is greater, even that of the highest frequency.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can also search on the net but there is no answer, even here they deign each other, what to say, congratulations and patience.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you put in a support request or asked on the card maker (asus,msi....?) support forum (if they have one), ask them what it should be ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
They don't answer.
If you check your card, even if the "model parameters" change, do you have the "same thing"?
But above all, why this thing?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Searching the Internet also in other "original bios" is the same thing, the voltage "at this point" is even greater than the last value with the highest frequency, why? possible cannot be known? And nobody talks about it 😞
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I didn't get it what it is exactly? and how it will help in creating software like it? As I working on a website then will it help me?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think the question may be concerned in your case.
I explain, curiosity started in the case of a RX580 video card, On opening the standard settings - performance - Optimization - GPU optimization - Tension (MV).. It should be noted that at the "step 5" with "1233MHz" the tension (mv) is "1193"
While in the subsequent "3 steps", with higher MHz the tension (mv) is lower and is "1150", we wondered why this thing, also because it also repeats itself on other cards (and bios) even if they are different models and with different values.
That's all, but nobody talks about it.
