cancel
Showing results for 
Search instead for 
Did you mean: 

PC Graphics

bob-r
Adept I

No signal after driver install (RX 570 on GA-H61M-S1)

Good day fellow users!

I guess the title is self-explanatory.

-I can enter bios and boot on safe mode, but once I boot on normal mode I can only hear the windows boot sound on speakers so it's missing the video signal only.

-It shows signal again when I disable the RX 570 driver on devices manager.

-GPU: Gigabyte Radeon RX 570

-Mobo: Gigabyte GA-H61M-S1 (rev. 4.0)

-PSU: Corsair VS500 (500w)

-Cable: HDMI

(more information on screenshots attached to this post or ask me)

Any possible solutions? If no, should I bake the GPU? Use the RMA if it's still possible?

Or maybe it's incompatible at all and I should try to exchange for an older GPU?

Thanks in advance for any information or idea!

1 Solution
bob-r
Adept I

2 years later I realize that the Samsung monitor was showing "Function not avaible", not "No signal", so the problem was the monitor. I tried lower resolutions but got the same message.

So I pluged hdmi in a LG TV I have now, turns out it worked perfectly fine.

View solution in original post

0 Likes
4 Replies
rashx27
Journeyman III

Have you managed to fix the problem?

Cause I have the same card and the same motherboard.

If you fixed it please post a solution.

No solution yet. I'll get back to search now I have the time,

please let me know if you find any useful info too!

0 Likes

As you can see it's been detected properly, the problem is when I install the driver so it works fully, but then get no signal.

graphics.jpg

image.png

0 Likes
bob-r
Adept I

2 years later I realize that the Samsung monitor was showing "Function not avaible", not "No signal", so the problem was the monitor. I tried lower resolutions but got the same message.

So I pluged hdmi in a LG TV I have now, turns out it worked perfectly fine.

0 Likes