PC Drivers & Software

[thepixelsurgeon]

I am only using curve optimizer, OC is set to default. I have noticed that the BIOS OC setting are adjusted even in Default mode when applying Curve Optimizer. But my question is, does Ryzen Master settings stick, or do I have to open the application after each system boot , and do I have to apply the setting each time? This is for Curve Optimizer only. 

Ryzen 7 5700X

MSI X570-A Pro - Bios 5

[FunkZ]

Yes, when using Ryzen Master settings need to be reapplied after a reboot. If you had changed a lot of settings you could save them as a profile, then just reload the profile after a reboot. Since you're only using CO that's not really beneficial.

If you're looking to make it more permanent then you can set it in BIOS. Those will remain set until a new BIOS is flashed.

[thepixelsurgeon]

Thanks. Running curve optimizer set the under-volt at -30 at first, then -26 and -27. Since I can only enter -25 or -30 into my Bios (increments of -5 millivolts), I tried a -25, the machine was not stable and could not even boot up again. I had to reset, boot into Bios again and remove the manual under-volt. For some reason my machine does not like this. 

It runs fine with CO set in Ryzen Master, did multiple stress tests and processed loads of images since using Ryzen Master. CPU temp dropped by 10-15 degrees, 

[FunkZ]

Odd that -26 or -27 is stable but -25 is not.

That's unfortunate that you can't select any setting from 30 to -30 in the BIOS. What board do you have?

[thepixelsurgeon · Accepted solution]

It's a X570-A Pro. CO is stable though Ryzen Master, but not manually entered into Bios, very weird.