Power lines are usually 7200 volts and then a 50kva or whatever transformer transforms that down to two phase 240 in the US, a 200 amp breaker pretty standard. That transformer is a couple coils of wire wrapped round a couple iron cores wrapped in a metal cylinder basting in usually caster oil. I know there is impedence. But that is roughly 65 Horse power… That's a lot of heat. I picked a gas pump because the rubber in a water system would deteriorate. I actually built a aquaponic system with fountain pumps. Gasoline is one heck of a solvent, and gas lines on sport bikes can handle some preasure. mineral oil by comparison is much more inert but will still eat water stuff. I want to delid a gpu/cpu no fins no goop just mineral oil copper lines and a 12V 2A Gas pump for a sports bike again because if it can handle gas at high bar it can handle mineral oil through copper flairs, a filter, and crimped ends. I also used to play with muratic, nitric, acids,13.5 bases, Hg, Microwave viscosity meters, Nuclear viscosity meters refracto-meters, flow-meters, H2S calibration, Nuclear density switching, And human hair that curled when it got humid… For Real... at a measurable rate(Fisher-Porter device). So uh yeah I kinda have whacky ideas involving venture’s, Harmony drives, and Honda K24’s. If I had funding I would either start a techno cult or blow myself up trying( not really but its possible) The other whacky idea I have is Freon because might be easier to seal the system.
