- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
AMD Raid SMART for Legacy HDD
Hello,
I have built an AMD Raid with the B550 chipset. I need a failsafe for the Windows boot partition and therefore used a RAID 1 for the 2 SSDs. So far everything is good.
For the Raid1, the SMART tool "HDSentinel" also displays the SMART values. (Unfortunately it does not work with CrystalDiskInfo)
But for the two "Legacy-HDDs" no SMART value can be read out! Is there a way for this?
What is actually the correct configuration for the following scenario?
I want to protect the boot partition via RAID1, but all other hard disks do not need RAID functions. Is it correct to use these HDDs as LEGACY or would I have to make a JBOD out of it? Or is there a possibility that I don't need a RAID driver for this at all?
RAID-Driver-Version: 9.3.0-00266
Thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That's not correct. HDSentinel can read the SMART from RAID1 correctly
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can confirm that HDSentinel is showing the SMART Data correctly, except for the NVMe RAID.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Do you plan to support this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, reading of smart data when using Raid is not supported.