AnsweredAssumed Answered

Not able to step into OpenCL kernel using CodeXL debug mode

Question asked by pixelclear on Mar 10, 2019
Latest reply on Mar 11, 2019 by dipak

I have RX580 GPU and writing an application in OpenCL. I want to step into OpenCL kernel code and debug it.

I have installed CodeXL for this purpose but when I do project settings and set a break point at the clEnqueueNDRangeKernel function. So that I can step later on into my kernel function. But my break point is not hit. Following are the settings I am doing for launching session.

 

You can see in еру following picture, break points are validly set.

When I start debugging, my application runs and exits but breakpoints are not hit.

I am not sure If I am missing any pre-requisite installation for CodeXL or something is wrong in project settings.

Outcomes