0 Replies Latest reply on Jul 10, 2018 1:06 PM by openskyz

    Xenserver issue with MxGPU

    openskyz

      I have been attempting to get a FirePro S7150x2 working in a Dell R730 with latest firmware (2.8) for several days now.

      It is running Xenserver (tried 7.5 and 7.4) without success.

      I can get the card installed, and then install the mxgpu gim driver, the modprobe/info/lspci

      commands show the correct entries. The card also shows up in the host correct in

      XenCenter.

      I then install a Win10 VM and after installing XenTools and such, I reboot, then shutdown and add the GPU,

      on XS7.5 sometimes the VM will not boot from that point on, just hangs, quite often the server needs to be reboot to be

      able to attempt to boot again as well as remove the gpu resource.

      One time I was able to get the VM to boot, add the Radeon Pro driver, but on reboot of the VM

      it paused on black screen for quite a while, then blue screened with TDR failure

      with atikmag.sys error.

      I then tried to go back to Xenserver 7.4, again I can install VM and such, and add the GPU, I can also add the client driver, and

      reboot, the first attempt will normally boot up then crash with blue screen after 30-40secs.

      After it crashes, the VM will no longer see the AMD GPU, it still shows up fine in XenServer, but the VM won't see it, I must reboot

      XenServer then the VM will see it.

      Any ideas?

      I have read there may be firmware specific to server brand, HP, Dell, or Retail, can anyone tell me how to find the

      type of card and the firmware installed?

      Can anyone provide what version it should be running?

      Can I get the VBIOS for the Dell and a flash utility?

      Been using the 18.Q1 drivers and the 1.0.5 GIM driver for XenServer.

       

      I have submitted the above via email to global support, but so far they have been slow to respond and have not really gotten past basic info so far.