Did you load BIOS defaults?
I set the bios settings to default. I also installed another bios. All bios versions have the same problem. But I did not do anything.
Did you turn off some cores in bios or ryzen master? Might try reinstalling the drivers.
Best practice is to reset to defaults BEFORE flash, then flash and then may clear CMOS just before reconfiguring BIOS.
Make sure you didn't disabled cores in BIOS itself.
Friends. I did everything you wanted. But the problem is: The computer rarely turns on. I get an error when I try to reload the bios. Actually, it's loading bios. But when I save the settings with F10 it never opens again. I installed the bios using the bios flashback feature behind the motherboard. But again the PC is not turned on. Sometimes the system is on. I enter the bios settings and save the default settings with F10. But the system is not opening yet. I did not use Ryzen Master. I did not disable any nuclei. I use the Bios settings as default. This happened after Bios was updated. Is my processor broken? Or is the motherboard broken? The question is, How and why did the PC that was stable after the bios update default settings come to this state?
I would go to ASUS forum and ask this question in this section
If you would have access to different ryzen to test it would help answer if it is CPU or mobo...
BTW - try to boot with only one RAM stick in different slots and resocket CPU too.
check the CPU tab in your BIOS and make sure it is recognized properly
then check to be sure all cores are being recognized
I checked all of them.
I tried the following to solve the problem:
- I updated it to another bios version.
-Bios battery was removed and plugged back in.
-I always reset bios to default settings.
- Already, I always use my computer with default settings.
- I never overclocked during use.
I never used the Ryan Master program.
- I never canceled the processor cores anyway.
-The system was stable.
I installed the -1602 Asus C6H bios.
-F1 screen came.
If you save it without saving it, the system processor will be opened as a single core.
If I save and exit the settings with F10, the system will never be turned on.
try optimal defaults
No need anymore. I solved the problem very easily.
I even solved the following problems easily with a single operation.
- Cold Boot problem
- High frequency ram stability problem
- Bios still not stable
- Ram incompatibilities
I have solved all these and similar problems very easily.
I sent back my motherboard and processor!
Now I am very comfortable and I have no strange problems that are annoying and unclear when it will be solved.