I am looking to force my pc to try Eyefinity PLP on my Club3D R280. I know I only have the 1.1 GCN but I would like to know if I can make it try anyways.
No, PLP is not supported on the R9 280.
I understand it is "not supported" but its just calculations. so I was wondering if there was an UNSUPPORTED way to FORCE it. just like a pair of pliers could be used as a hammer if you absolutely needed one. even though "hammering" is "not supported" by the pliers.
As far as i know, no.
Retrieving data ...