2 Replies Latest reply on Apr 24, 2017 12:28 PM by ray_m

    I Lose Signal Immediately After Installing GPU Drivers off of CD

    peerpsi

      Immediately after installing Windows 10, 64 bit, I'm using my MSI R9 390X installation CD to load the latest drivers.  It gets about halfway through the installation of V15.xxxx, and then my monitor loses signal.  I can boot to safe mode and see that the driver installed, but for some reason its causing this loss of signal.  Device Manager shows that my basic Acer monitor has an exclamation point next to it, but I have no drivers to update it to.

       

      I downloaded the latest driver off of here, a Crimson ReLive 17.4.3, and I tried to install it overtop of 15."whatever" from the disc, but I get a "failed to load detection driver" when I try to.  Any ideas?

       

      O.S.: Windows 10, 64 bit

       

      CPU: AMD FX-8350, 8 core 4.0 GHz

      Mobo: Asus m5a99fx pro r2.0

      PSU:
      Rosewill Capstone G1200 Continuous 1200W

      HDD: 250 GB Samsung 850 EVO SSD

      GPU: MSI R9 390X

      RAM: Two sets of Corsair Vengeance 8GB (2X4GB) DDR3

       

       

       

       

      Thanks,

      Peerpsi