This week i purchased a 4K Philips monitor (BDM4065UC 40", 4k)
I also bought the Radeon RX 460 2GB D5 because my old Graphics card couldn't handle the 4k resolution.
I have installed al my new hardware but i'm still not able to get above 30 Hz (refresh rate)
I use a dislplayport connection btw.
With CRU i have managed to reach 60 Hz once, but after restarting my PC, the refresh rate dropped to 30 again, and now i'm not able to get it up to 60 again.
I have tried to change the settings in the Crimson setup (change resolution manually or something) but then i get a fault that a error between display port and the monitor that is causing the problem..
Can someone help me out here?