Hello when I update to the latest driver my fps is capped at 30fps with v-sync on so I have to go back to the 15.11 driver for it to be at 60fps is there any fix to this? thanks!
Is it from MSI afterburner? or what?
Third party programs such as Afterburner have had reported issues with Crimson. I would try disabling and revert any changes you made with it. Then perform a clean install of the 16.5.3 drivers. Also, check that you have moved your Power Limit to +50 (or +20 depending on the card)...here's why > AMD graphics performance
I also use Frame Rate Target Control with Vsync.
Not sure which game you are talking about, but sometimes after updating drivers, a game will reset its settings. In this case, it might have selected a resolution with 30hz refresh rate. You can also make sure that you do not have Frame Rate Target control set to 30, or something similar in the game capping FPS. Also, it's a good idea to make you have the proper monitor driver installed. If this is a TV, then you might have to fiddle with the HDTV tab in additional settings popup.
Well I tried all of that it still does not work on Rainbow Six Siege is there something wrong with my card?
I tried reinstalling windows it did not work
INFORMATION REQUIRED WHEN POSTING A QUESTION
AMD R9 390 8GB XFX
WINDOWS 10 64
LG FLATRON E2350 1920x1080 @60HZ HDMI
600W xigmatek power supply
8gb Adata 2133mhz ram
FPS IS CAPPED AT 30FPS WITH V-SYNC ON WHEN UPDATING TO THE LATEST DRIVER THIS PROBLEM DOES NOT OCCUR WHEN I GO BACK TO 15.11 DRIVER.
THANK YOU SO MUCH IT WAS THE POWER EFFICIENCY WAS TICKED ON!
Retrieving data ...