I have an 8 monitor W7-64 bit system with two ATI 2460 video cards installed and operating perfectly on Disk 0.
Recently, I set up a 2nd HDD (Disk 1) and need guidance on how to get the drivers to run when I boot to Disk 1.
Disk 1 also has windows 7-64 bit installed and boots properly except just two sad little monitors running.
Do I install the drivers again on Disk 1?
I looked at the BIOS and don't see anything helpful there.
Thanks in advance.
there should not be a problem installing drivers on a secondary hard disk. Make sure RAID is off. As a test can you disconnect Disk 0 and see if you can install FirePro 2460 drivers properly and configure 8 monitors?