Archives Discussions

[jossgray]

Is there any log that gives detailed information on the genlock process.

I'm having a problem getting displays to genlock, but can't identify whats the problem.

After about 10 seconds the screens flash and go back to an un genlocked state.

We're using 30Hz SDI to genlock 60Hz screens, with a scan rate coefficient of 1:2.

[chm · Accepted solution]

Hi,

unfortunately there is no logging that would help to determine the cause for the genlock loss. If the genlock is lost it is most likely due to frequency changes is the reference signal. I think the reference timing should not change more than +/- 5us otherwise you can lose sync.

Chris

[jossgray]

Thanks Chris.