I have a serious problem regarding debugging with CodeXL. Whenever I try to debug any OpenCl kernel, it is not working. What happens?
Variables are not read correctly. Even the simplest operation fails.
int offset = 1;
The offset is set wrong. The debugger displays a complete wrong value(e.g. 0,64, 67...). Many If-clauses are not entered, because either the variables are wrong set(bools are sometimes displayed as Int and have a totally wrong value) or the If-clause is not entered(even, if the variables have correct values and should enter the If-clause). Sometimes the debugger just aborts the debug session. Mostly it happens at the same line or operation.
If I use the profiler instead of debugger, it is highly possible, that the driver resets or a BSOD is displayed^^.
Before I describe more problems, heres my System:
Dell Vostro 3450
Intel Corei5-2410m (integrated Intel HD3000)
4GB 1333Mhz DDR3
AMD HD6630m (Turks) 512MB
Catalyst 12.2 Unfil up5
Because the most drivers(except the original and very old ones from Dell) dont work(no switchable graphics enabled, CCC not functional), I went to modded drivers(Catalyst 12.2 Unfil up5). Those modded drivers are workable, but not for Opencl... Mobility drivers from AMD dont work(tried many different ones).
I am using the InsightToolkit(ITK), which encapsulates OpenCL in its own methods and classes. This toolkit is open source and used for medical image processing.
Heres the Code:
This kernel checks for the max and min val of an array. The worksize is 64(4*4*4).
I've also added a picture about the output of CodeXL. If I step through the kernel, it just stops.
€: Heres the Bluescreen data.
Zusatzinformationen zum Problem:
OS Version: 6_1_7601
Service Pack: 1_0
€2: IMO the problem are an incompatibality of drivers and the Opencl RTE. As well the integrated Intel HD3000 could cause some problems. The BCCode indicates some driver issues.
Unbenannt.png 15.4 KB