Showing results for 
Search instead for 
Did you mean: 

Graphics Cards

Journeyman III

RX 5700 XT out of range issue


I recently put together a computer comprised of the following parts:

- MSI b450 gaming plus motherboard

- AMD Ryzen 3700x CPU

- AMD RX 5700 XT stock cooler GPU

- 3200Mhz G.Skill 2x8GB RAM

Before even putting the CPU in the socket, I flashed the BIOS to the latest version which supports Zen 2 CPUs.

I then went and plugged the GPU to a screen (Asus VG255H) by means of an HDMI cable. When I turned the PC on, debug LEDs on the motherboard got stuck at the last step: BOOT. This was expected, as the SSDs connected were brand new, with no OS on them. However, no splash screen showed up, neither the BIOS if I tried to open it using the correct key. All that appeared on screen was "Out of range". Do note that the debug LED for VGA had turned on and off, and the GPU fan was active, indicating that the GPU was up and running (as far as the motherboard is concerned).

The error message differs from the one I get if I try to connect the motherboard to the screen directly with the GPU in place. The screen says "No signal" in that case.

It's a 1080p75Hz monitor according to specs. 2 different HDMI cables were tried on both screen ports.

I think I've isolated the problem as coming from the GPU. That is because I'm writing this on this very PC, except with an old graphics card inside instead (Nvidia GeForce 460 SE). With this other GPU, everything runs great. I tried putting the 5700XT in the PC this other card comes from, same problem now ! (I checked that it worked just before, using the 460SE).

Does anyone else have this problem? Has anyone solved it before?

2 Replies

Have seen a number of reports on issues running 75hz monitors with the card, most workarounds are to run monitor at 60hz until a driver fix arrives.

Ryzen 5 5600x, B550 aorus pro ac, Hyper 212 black, 2 x 16gb F4-3600c16dgtzn kit, Aorus gen4 1tb, Nitro+RX6900XT, RM850, Win.10 Pro., LC27G55T..
Journeyman III


Thank you very much for the tip. I was starting to think the card is defective.

According to your tip I went and purchased a VGA to HDMI adapter. That way, I could link the HDMI output of the card to the VGA in of the screen which expects 60Hz. The image quality was terrible with only 1Hz refresh rate (crazy flickering) BUT I could then install the necessary drivers so as to then use the HDMI cable... What an adventure !