On a Sapphire RX590 card I have one desktop display connected via Displayport, and two via HDMI. I also have a link to my AV Amp/TV via the DVI connector.
Normally I have the AV Amp display disconnected in Windows 10, however, when I start Eyefinity it insists on seeing a 4 screen setup, unless I physically unplug the DVI connector.
Is there any way to prevent this so it only sees the 3 screen setup?
As a secondary question, possibly related as it again relates to recognising Windows 10 configurations, my 3 desktop monitors are the same res (1920 x 1080) but different sizes. If I modify the res of the smaller ones in Windows so that I'd then be able to realign them in Eyefinity, that change is ignored. Any suggested solutions for this?
The good news is that by trial and error I found that is is possible to eventually save a preset with an eyefinity display group of just 3 screens.
The bad news is that you can't launch straight into a preset. You have to go via Radeon Settings -> Eyefinity -> Quick Setup, which creates an Eyefinity group on the fly (of 4 screens).
If I then got to the advanced features and enable a preset, "Unpredictable results may occur". It's favourite is stopping eyefinity, disabling all but one monitor, and switching that monitor to 3200 x 1800, so I then have to manually re-enable and resize my monitors in Windows.
Am I missing a trick here?
I too am unable to do this. It seems the catalyst software from my old 6950's was more intuitive that the Radeon software for my ROG-STRIX-RX5700XT-08. Kind of ridiculous i'd say.
I only wish to use my 3 screens and exclude my TV. grrrrr