Not able to step into OpenCL kernel using CodeXL debug mode
I have RX580 GPU and writing an application in OpenCL. I want to step into OpenCL kernel code and debug it.
I have installed CodeXL for this purpose but when I do project settings and set a break point at theclEnqueueNDRangeKernelfunction. So that I can step later on into my kernel function. But my break point is not hit. Following are the settings I am doing for launching session.
You can see in еру following picture, break points are validly set.
When I start debugging, my application runs and exits but breakpoints are not hit.
I am not sure If I am missing any pre-requisite installation for CodeXL or something is wrong in project settings.