cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Archives Discussions

glammers
Journeyman III
‎11-13-2013 02:54 PM

Unable to connect to CodeXL Remote Agent

I'm attempting to use the new CodeXL Remote Agent on a SLES11 system. Starting the agent gives the following message:

********************************************************

CodeXL Remote Agent settings were extracted successfully

--------------------------------------------------------

Agent version is: 1.3.3487.0

Read  timeout is: Infinite Timeout

Write timeout is: Infinite Timeout

Agent IP:Port is: 127.0.0.2:8080

********************************************************

CodeXL Remote Agent is listening on <127.0.0.2:8080>

Press any key to terminate CodeXL Remote Agent. . .

Based on the listen address, the agent appears to be using the loopback interface. When I attempt to remotely launch a profiling or debugging session, I get an error message that CodeXL is unable to connect to the remote agent.

Port 8080 is not blocked by any firewall.

I looked for some configuration option to change the interface used by the agent, but I was not able to find anything. Any suggestions?

0 Likes
3 Replies
amitbm
Staff
Staff
‎11-14-2013 05:04 AM

Hi,

Can you please attach an ifconfig trace?

Thanks.

0 Likes
glammers
In response to amitbm
Journeyman III
‎11-14-2013 11:43 AM

Sure. I've removed the actual addresses from the eth0 interface, but they are real IPs, not 127.x.x.x

eth0      Link encap:Ethernet  HWaddr 90:B1:1C:02:C1:24

          inet addr:#.##.##.##  Bcast:#.##.##.##  Mask:255.255.252.0

          inet6 addr: <address>/64 Scope:Link

          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1

          RX packets:14539 errors:0 dropped:0 overruns:0 frame:0

          TX packets:1479 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000

          RX bytes:7653632 (7.2 Mb)  TX bytes:169959 (165.9 Kb)

          Memory:dad00000-dae00000

lo        Link encap:Local Loopback

          inet addr:127.0.0.1  Mask:255.0.0.0

          inet6 addr: ::1/128 Scope:Host

          UP LOOPBACK RUNNING  MTU:16436  Metric:1

          RX packets:198 errors:0 dropped:0 overruns:0 frame:0

          TX packets:198 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:0

          RX bytes:12344 (12.0 Kb)  TX bytes:12344 (12.0 Kb)

0 Likes
amitbm
Staff
In response to glammers
Staff
‎11-20-2013 08:46 AM

Please send an email to: DevTools.Support@amd.com. Our teams will get back to you and provide you with a solution to your problem.

0 Likes