Showing results for 
Search instead for 
Did you mean: 

Archives Discussions

Journeyman III

R200 crtc2 engine issue for tvdac

We are trying to develop an M9 driver for a graphics card without a BIOS(instead we need to supply the timing stuff). Our driver should support both (primary /secondary display) heads and also a configuration with DVI + TVout on the secondary head @1024x768. However tvout and dvi require different VTotal values (NTSC:959, DVI: 806) in order to display properly. When we setup the crtc2 engine for VTotal=959, the connected DVI monitor does not display and for the Vtotal=806, tvout image is incomplete and have scaling artifacts. We could not find an intermediate value to display at both tvout and dvi for the secondary head(crtc2).

In order to separate DVI settings (i.e VTotal, Htotal, Vsync...) from the crtc2 engine, I tried to use the flat panel crtc shadow registers (the ones with fp_ prefix). I observed that they work fine for the crtc engine. However, I could not find an fp crtc shadow register to change the VTotal value which I was hoping that would be the key for the solution. In xf86 code I found an undocumented  register (FP_CRTC2_V_TOTAL_DISP  0x354). However, writing to this register had no effect when shadow registers are enabled. Therefore, I'm not sure if this register really exists on M9.

Anybody has an idea on how to display tvout and dvi on the second head (display)?

Note that we need to use a specific LCD output (DVI) device that strictly obeys VESA modes.

2 Replies

Can you please email gpudriverdevsupport at amd dot com ?


Issue posted to gpudriverdevsupport at amd dot com.

Edit: Reformatted email to reduce spambots