cancel
Showing results for 
Search instead for 
Did you mean: 

Archives Discussions

super_xu
Journeyman III

Can Firepro W600 drive a 2X2 1920*1080 screens?

Hello, I'm using the FirePro W600 to realize a 2X2-screens display. The Resolution of a screen is 1920*1080. When I connect one screen with the display card, the maximal resolution which can be captured is 1366*768. I have found that the resolution can be changed in the drive software, but there's some risk and I need to set some parameters. Can you tell me how to set the parameters in the software? The setting page is the following image.分辨率设置.png

0 Likes
1 Reply
chm
Staff
Staff

Re: Can Firepro W600 drive a 2X2 1920*1080 screens?

Hi,

typically the monitor will report its capabilities to the graphics driver by submitting its EDID. This one contains the modes that are supported by the monitor. If the monitor really supports 1920x1080 it should be listed as resolution in the Catalyst Control Center->Desktop properties. If not you might want to double check how the monitor is connected e.g. if you use miniDP to DVI dongles that are supported. A list of qualified dongles can be found on: AMD Eyefinity Technology - Recommended Adapters

If for some reason you want to add a resolution which is not listed you can add so called custom resolutions. I would recommend using the CVT-Reduced Blanking Timing standard. The you just need to enter the required resolution and refresh rate to get the mode added.

CVT.jpg

Please note that if you want to create Eyefinity Display Groups those custom resolution will not be taken into account.

Chris

0 Likes